|
|
|
|
Inflatable toys Department of polyvinyl chloride (PVC) films by high-frequency welded, showing a variety of shapes by inflation, it is also known as inflatable toys, inflatable toys. Its shape in the majority of animals, the water supplies of the other toys spare tire. The use of inflatable toys are also targeted to infants and young children. When the child was born two months later, you can pick some colored inflatable sphere hanging in the bed in order to exercise the child's vision. In addition, choose a number of exaggerated animal toys for kids dabbling. When the child reaches the age of later, before they are allowed to choose water toys such as the spare tire and the like. It must be noted, toys spare tire do not have to survive only as a toy frolic in the water. Therefore, parents must not put the spare tire as a life preserver to use.
Modeling choices: the selection of inflatable toys in the shape to meet the interest of the child. Less than the age of the baby, choose bright colors, large blocks of color and sleek shape of toys, such as color balls, duck, goldfish. The selection of these animals should pay particular attention to the color of his eyes and cute. Other aspects can be omitted. Later when the child years of age, you should pick some realistic modeling of the animal, even with the horrible animals, so that small children see the world, cultivate the spirit of the brave. In the selection of inflatable water toys, in addition to the spare tire outside, can also choose some aquatic animals such as ducks, swans and goldfish.
Two. Tightness check: inflatable toys quality of the sealing performance, quality inspection is to check the leak or not. First of all, should not inflatable toy stalls, observe whether the prints are clear and beautiful, the main parts of the chromatic accuracy surface with or without stains and yellowing. Soldering should seam between each film uniformity, good melting, there is no wrinkling and pimple phenomenon occurred, there should be clear of sealing off. With your fingers graze the film surface should be no discoloration. Around the observed gas nozzle welds should be sealed tight good gas nozzle plug and the gas nozzle with close but not too loose. Inflatable toy observed against the light, should not be found within the foreign body shadow.
Check before charging into the air. When filled with air pump or other means, toys should show the full shape, and smooth to stand on the desktop instead of rickety. Some toys may have a center of gravity, after adjustment, tilt should be obvious. Inflated toy surface should be smooth and no obvious sag and wrinkle. Hand soft reduction of toys, and the gas nozzle on the ears should not hear the leak sound. Inflated the best toys remain standing for the position for five minutes, observed without significant deformation or standing firm. When the above checks are normal, you can put the gas nozzle plug pulled out the toy natural deflated, if not hand pressing toys, its internal air should be able to remain a part of, rather than all over the world.
After the above checks, you basically can choose a good quality inflatable toys. However, the shortcomings of aging over time due to the plastic film of such toys, so place a long time, the film may harden while the phenomenon of chronic leak occurs, the problem at this stage can not solve, with the continuous improvement of film quality , the Achilles' heel of the inflatable toys will be gradually overcome.
|
|
