Ever wanted to set your folded clothes on a shelf out of the way of the pile of clothes resting on top of your dryer? It gets difficult when you're pulling wet clothes out of the washer. Looking for a place to set your detergents, bleaches, and stain-removers? You may need a countertop or shelf in your laundry room. If you decide to take the road to organization your countertop shelving will need support. If it doesn't have solid supports it will lack stability and strength which can lead to a countertop loosening and falling - dangerous to those around your washer / dryer unit - children, small animals and your personally. Federal Brace makes shelf brackets that are capable of holding a countertop in a laundry room. I am going to tell you how easy it is to install. Things You'll Need:
- Shelf Brackets from Federal Brace
- Stud Finder
- Construction adhesive
- Power Drill
- ¼" Screws
- Power Screwdriver
- A Level
- Pencil
You're going to have to use a stud finder to find wall studs along the entire length of the countertop. Mark the wall stud locations with a pencil. Take the first bracket. Position it against the wall on the first stud mark. Figure out how high you want the shelf to go. Once you have reached your desired height you can make another mark. Take a ¼" screw and a power screwdriver and place the bracket back where you want it to go. Drill through the bracket holes into the wall with your ¼" screw. Once it is secure you can move on to the second bracket. Take your second bracket and move to the second stud mark. Move the bracket to the same height as the first bracket and use a level to make sure that the countertop is straight. Once you have a solid position mark where the bracket will go.
Take a ¼" screw and a power screwdriver and place the bracket back where you want it to go. Drill through the bracket holes into the wall with your ¼" screw. Now you have your two brackets up. Time to put up your shelf. You should put construction adhesive on top of the brackets. Be careful not to put too much material on because it will leak over the edges. After it sets for a few seconds you should be ready to apply your shelf. After the shelf dries for a bit it should be set and ready for use. By the way, the number of is determined on the length of shelf you will be using. If you are using a gusseted shelf bracket (or bracket with a cross brace between the supporting flanges) then Federal Brace suggests using a bracket at no more than 24" spans. Check out our helpful video on the subject as well so see more info. Please make sure to check out the shelf brackets at FEDERAL BRACE. Thank you. Have a great rest of your week!
|